Laserfiche WebLink
<br />SUBJECT: ORDINANCE #2005-2 AMENDED (OVER DIMENSION VEHICLE REGULATIONS) <br /> <br />ADOPTED DATE: FEBRUARY 19, 2008 <br /> <br />PAGE 11 OF 23 <br /> <br />b. Overweight permits are not valid for movement on flexible pavements when the <br />atmospheric temperature is 850 F or above. <br /> <br />2-07. Additional conditions for all overweight movements. <br /> <br />a. Loads would have to be broken down as follows if requested routes of travel <br />cannot be approved by the County Engineer or Sheriff. <br />1) Blades and rippers must be removed from dozer and hauled <br />separately. <br /> <br />2) All scrapers must be split and hauled separately. <br /> <br />3) Counterweights must be removed from cranes and hauled separately. <br /> <br />4) Self-propelled truck cranes shall be allowed a maximum of 550 Ibs. per <br />inch width of tire without an additional overweight fee, up to a <br />maximum gross vehicle weight of 150,000 Ibs, anything over 150,000 <br />Ibs. gross vehicle weight will be charged rates listed <br />Weights in excess of 550 Ibs. per inch width of tire shall be assessed <br />a fee in accordance with the fee schedule for each additional weight <br />per axle configuration on self-propelled truck cranes. <br /> <br />5) During spring weight restrictions, all truck cranes shall follow the <br />standard over dimensional policies. <br /> <br />b. All movements are subject to County Engineer or Sheriff approval. <br /> <br />2-08. Additional conditions for movement of overweight self-propelled earthmoving <br />equipment such as scrapers, rubber-tired dozers, and loaders. <br /> <br />a. The maximum permissible axle weight when roading earthmoving equipment is <br />36,000 pounds per axle except as authorized by the County Engineer. <br /> <br />b. County Engineer or Sheriff may authorize permits when the axle weights <br />exceed 36,000 pounds. <br /> <br />c. Earth moving equipment is not allowed to be loaded with material when roading. <br /> <br />d. Maximum speed for movement is 20 mph and a pilot car is required to follow for <br />this purpose. <br /> <br />e. All general travel restrictions and requirements of this permit policy apply to self- <br />propelled earthmoving equipment movements. <br />